hyCLEANER solarROBOT pro lichen remover

Description

hyCLEANER solarROBOT lichen remover is the innovative new tool for tackling lichen without the often problematic use of chemicals, even on large surfaces. Due to the relatively low pressure, the fixed distance to the panel and the constant impact angle of 90°, it is a very gentle cleaning method that does not damage the substrate. Due to the special vortex and rotation nozzles, the water is given a special swirl that breaks up the lichen even at low pressures and "tears it off the panel".

The innovative cleaning attachment is installed on your existing solarROBOT pro in place of a brush and has an M22 connection for normal high-pressure hoses.
The second brush remains on the robot and polishes and rinses with clean water after the lichen has been removed.
Due to the high water consumption of the lichen remover of approx. 1200 liters per hour, we recommend using the lichen remover with a suitable high-pressure cleaner at max. 90 bar and use the remaining brush as usual with clean water if a clean water supply of 1200 liters per hour is not feasible. In this way, you can remove the lichen and clean the surface in one work step without the dirt and lime-containing dirt drying out.
The lichen remover can be used with 4 or 6 nozzles and is supplied in the larger version. It then has a working width of approx. 110 cm.

Instructions for use:
- May only be used on PV systems with an inclination of up to 20°.
- All guidelines in the operating instructions must be strictly followed.
- The hose guide may be impaired during operation.
- Thorough rinsing of the panels is required after use.
- Attention: Can only be used in conjunction with the solarROBOT pro!
- Two separate hoses are required to use the lichen remover in combination with a brush. In this case
cannot be used with a hose guide.