REACH-iT Z-Force glass scraper with water guide for telescopic rods

Description

REACH-iT Z-Force Glass Scraper with Water Guide is one of the most innovative glass cleaning tools we have ever seen.
It combines the two worlds of traditional glass cleaning, where glass scrapers, blades or planes have always been used, with the benefits of osmosis cleaning and continuous rinsing with demineralized pure water.

Professionals know: For certain types of soiling on glass (building cleaning, bitumen, stickers, etc.), I can't avoid using a glass scraper.
In some regions it is also called a "blade", "scraper" or "glass scraper". It always means the same thing: A sharp and robust blade that is used to "cut" dirt from the glass with maximum mechanics. This professional standard tool in glass cleaning - it should only be used by professionals due to the risk of scratching and the problems with modern toughened safety glass - was previously always associated with ladders, scaffolding and cherry pickers above arm's reach.

The Z-Force glass scraper now takes the glass scraper to new heights and also improves work ergonomics and working speed.
It is therefore a glass scraper that is equipped with a rinse bar and is constantly rinsed by its own osmosis system or a clean water system (including the pane in front of it). Dirt, stones, etc. are thus permanently rinsed downwards, simplifying various work steps that are required for traditional "clearing" and eliminating the need for expensive and sometimes dangerous climbing or the use of cherry pickers, rolling scaffolding, etc. up to a working height of approx. 10 meters.
We would specify this range (i.e. 10 meters) as the limit for the usability of the scraper. Depending on the project and the type of soiling, this may be a little higher, or possibly significantly lower. In addition to pure handling (the pole must not tip over to the right or left due to the small contact surface of the blade), the issue of "visibility" should be mentioned here in particular. Even users with good eyesight quickly reach their limits here.
Please bear this in mind!

Thanks to the included 40-tooth ratchet for angle adjustment, the Z-Force can be installed directly on GARDINER poles.
Poles from various other manufacturers can also be used without any tinkering or additional accessories (OVA8, Tuchker, the old UNGER brackets).
An adapter is also included so that blades from Unger or Ettore can be used.

Whether this is necessary with the included stock of 260 Z-Force blades is up to you to decide!

A small note: Such tools belong in the hands of real professionals and glass cleaning experts, as they can of course also cause scratches in the glass, although the permanent rinsing with running clean water, which is always guaranteed in the Z-Force, means there is less risk than without this.